Hewlett Packard Enterprise recommends against downgrading firmware unless instructed to do so by a Hewlett Packard Enterprise support engineer. Always verify configuration settings after installing firmware. In those cases, a token in an autoloader or library with 2. To ensure complete compatibility, always upgrade to the latest version of firmware. Fixes The following issues are fixed in this firmware version: Fixed issue where drive support tickets might fail to be retrieved or have incomplete dataset if generated when HTTPS is enabled on the library.
|Published (Last):||1 July 2017|
|PDF File Size:||13.64 Mb|
|ePub File Size:||20.43 Mb|
|Price:||Free* [*Free Regsitration Required]|
Hewlett Packard Enterprise recommends against downgrading firmware unless instructed to do so by a Hewlett Packard Enterprise Support engineer. Always verify configuration settings after installing firmware. MSL Encryption Kit token with odd-numbered PIN length This issue concerns backward compatibility with some firmware versions released in when using the Encryption Kit, and does not apply to most current installations. When using firmware version 2. In those cases, a token in an autoloader or library with 2.
Users should always upgrade to the latest version of firmware to ensure complete compatibility. Enhancements The following enhancements are part of this firmware version: Added an option for FIPS Support Mode when using library-managed encryption. Made various RMI and event improvements. Fixes None. This event is the result of a periodic maintenance check of the network interface chip NIC by the library controller.
A similar event is generated if the network cable is removed and reinserted. Workaround: This trap and event can be ignored and have no effect on library operations. Workaround: Reboot the library. KMIP will be enabled after the reboot. Issue: The RMI does not allow connections although the autoloader or library can still respond to standard ping commands, the OCP is functional, and the communication with the tape drives operates normally. The only backup operations that might be affected are those configured for KMIP configuration.
This is a rare condition, but if the autoloader or library gets into this state while it is configured for KMIP encryption, backup operations can fail because KMIP keys cannot be retrieved. No autoloader or library reboot is needed. Issue: In rare instances, while upgrading the autoloader or library firmware, the autoloader or library may become unresponsive. Workaround: If the autoloader or library does not automatically reset after the upgrade and the front panel appears locked, power cycle the autoloader or library.
The autoloader or library will power up with the correct upgraded firmware installed. Click Update. From the Home screen, press Next until the screen displays Support. Press Enter to select. Enter the administrator password if prompted. Press Next until the screen displays the filename of the firmware file on the USB drive. Press Enter to select the firmware file. If the upgrade failed, press Enter to display the error code and message describing the cause of the failure.
Drivers & software
HP StorageWorks MSL4048 - tape library - LTO Ultrium Series Specs & Prices